Cleaner and Degreaser for Metal Restoration
Clean Bond is a powerful molecular degreaser engineered to remove oil, grease, and contaminants while preparing metal surfaces for coating and restoration.
- Cleaner, degreaser, flash rust inhibitor, and additional bonding agent.
- One gallon cleans up to 250 square feet.
- Helps prevent surface rust from forming for up to 3 days.
Product visuals
At a glance
Quick qualification for techs, facility managers, and distributor teams. Full details are in the spec sheet.
Why proper metal surface prep matters
Oil deposits, debris, and vapor residues prevent coatings from bonding properly. Clean Bond emulsifies and lifts contaminants, leaving metal surfaces clean and ready for the next stage of preparation.
Key benefits
Focus on outcomes that matter to operators and maintenance teams: cleaner operation, preserved performance, fewer complaints, and less maintenance churn.
Powerful degreasing
Breaks down oils and particles at a molecular level, making rinse-off fast and effective.
Saves labor
Spray-on application provides fast, thorough coverage, even in hard-to-reach areas.
Rust protection
When used in concentrate form, helps prevent flash rust on freshly cleaned metal for up to three days.
- Enhanced bonding: Contains a bonding agent that helps coatings adhere more effectively for long-term durability.
Part of a Complete 3-Step Restoration System
Step 1: Clean
Clean Bond removes oil, grease, and surface contaminants so restoration starts on a properly prepared surface.
- Degreases metal surfaces
- Helps inhibit flash rust
- Supports coating adhesion
Step 2: Repair
V570 helps address damaged metal areas and supports the transition from preparation to restoration.
- Pairs naturally after prep
- Supports system-based restoration selling
- Builds the repair stage before resurfacing
Step 3: Resurface
Pancrete completes the restoration workflow by creating a renewed protective surface in damaged drain pans.
- Completes the system
- Supports long-term resurfacing results
- Creates a stronger restoration story for distributors and contractors
How it works
- Prepare surfaces by removing loose or flaked rust and other debris.
- Mix Clean Bond at a 1:9 ratio with water for general cleaning.
- Spray the mixture onto surfaces and scrub with a clean broom or brush to remove oils and particles.
- Rinse thoroughly and wet-vac standing water.
- If coating is delayed, apply Clean Bond concentrate to freshly cleaned metal to help inhibit flash rust and support adhesion.
Ideal as the first step in drain pan metal restoration, especially where oil, grime, corrosion, and fresh-rust risk make coating preparation difficult.
- HVAC drain pan resurfacing
- Corroded pan preparation before Pancrete
- Metal restoration workflows using V570 and Pancrete
- Projects where coating cannot be applied immediately after cleaning
